Видео

If you put spary foam insulation, it will cool the shop literally by 20 degrees minimum

What happened man , this is my first time back in a few years

I watched this video 2 years ago , now I’m watching it again.Maybe time to go 1jz

Damn man miss seeing you in Adam’s videos haven’t seen ya in awhile

you need a guard on that cooling fan

Can you provide the contractor names?

More like the most over priced welder ever!

Old Thread but did you consider boring to 86.5 for 3.2l , 9.0:1 and turbo or were you focused on NA?

We need bigboost videos again

What subframes would a 318i need for a 2jz ?

Tell your sister in the front seat she is smoking Hot.

Where you at bruh

Are the CP carillo pisotns + BC rods good upgrade compared to stock 2JZ-GE non vvti pistons and rods? My block is going to the machine shop so I think I should replace the rotating assembly.

good video, where can i get these spark plugs? thanks alberto

Is this Adam Lz old mechanic😂

The fuuuhhhh was this click bait

Do you do this service for others? If so how much?

Hey you good?

Hey Alberto it’s been a minute, you alright?

Damn alberto speaks very good english now! Good shit man been years since ive seen your vids

Bro how did your wheel not fall one 😂

Than theres boosted boiz pushing 60 psi 😅

Are you running stock intake manifold with this cams.?

Dang I ordered the wrong one I got it for a 350z I didn’t know they made it for a g35 not my pipe doesn’t stick out 😭

She’s annoying

👍👍👍👍

Just switch on a VVTI head

I’m sure this thing blew up. Who does all this and puts old rings?

I see on the piston rings you went 2 steps on first one and 3 steps on second one….if I’m not immediately going turbo and just want to be NA for awhile would it be acceptable for me to only do 1 step on the first and 2 steps on the second? And tune accordingly

Did the machine shop use a torque plate to bore and hone the block?

I miss Alberto :(

Congrats BigBoost! This is awesome! How much the building?

Thanks!

I appreciate how detailed you get into every video . Thanks Big Boost!

What exhaust manifold you are using.??? Thanks nice setup 🔥🔥

For me the best machine thanks Miller

I bet that thing Leaked Like A Siv because you didnt put any tape on the oil cooler fittings 😬

Clean job 👍 BMW Recommand to prime the oil circuit after major job on it. N55 can quickly have rod bearing issue if the oil pressure is low. Pull out the fuel pump fuse, remove the residual fuel pressure in the rail so it doesn't start. Crank it 3x10s, let the starter cool in between.

What part of Florida r u in?

Where did you buy the parts from?

you didnt prime the oil system ?

Hey bori como estas i have a 2011 toyota sienna i want a nice muffler sound what do you recommend i use? Gracias eso suena heavy

the music at the end was magnificent !

It’s pronounced fuh not foe lol. In all seriousness tho greatful for the video, while I’ve welded a lot of difs I’m new to the VQ platform and haven’t touched a vlsd before. So appreciate this.

No rtv on the oil pans?

❤

You throw the whole thing out, build a K20a instead, and save yourself 200 pounds.

Your thumbnail had me excited (M52B38). I thought this was some exotic engine I've never heard about before now. Must have been a slip of the finger.

Very interesting. Did you install top chain guide or is it ok to run without?

El big boost